Views: 33 Author: Site Editor Publish Time: 2018-01-31 Origin: Site
Spraying grass planting, spraying sowing protection technology is the use of liquid sowing principle, tenacious vitality, and can meet a variety of greening function of plant seeds after scientific treatment and fertilizer, planting soil, fiber materials, water retaining agents, adhesives and water According to a certain percentage into the mixing tank after the mixture was stirred to full suspension, the mixture was sprayed directly onto the slope using a centrifugal pump or imported hose to the slope, forming a uniform cover under the protection of the plant seed layer, And then lay non-woven fabric protection, and forcing a green slope construction technology.
HYP Soil seeding steps:
一、Clean the slope
Clean up the debris on the slope, remove the pumice and loose rocks, cut holes in the concrete slope or break some of the concrete, and trim the slope to make the slope smooth so that the barbed wire can be laid. Check if there is a ditch at the top of the slope to prevent direct scouring of the sowing surface.
二、Medium preparation and spraying
The substrate added to the spray machine mix evenly, the material sprayed on the slope, the formation of material medium adhesion on the slope. Spray as much as possible from the front, to avoid supine jet, bump and dead parts to pay full attention to, do not miss, jet thickness as uniform as possible, but good conditions in the vegetative state may be appropriate to spray thin, less thick spray some of the conditions. Spraying three to five times, the first seed spray 2-3cm thick nutrient substrate, and then spray 3-4cm thick medium-based substrate sprayed seed medium containing the seed layer thickness of 1cm, each Sown square meters 20 - 41g. After sowing, barbed wire substrate area covered by more than 80-90%.
三、AB-type anti-rain erosion materials and anti-fern surface fibers
四、Covering non-woven or sun screen
五、Conservation management